TECNOCOAT

Hot spray coatings
DESMOPOL

Liquid membranes
TECNOFLOOR

Flooring systems
TECNOFOAM H2O

Polyurethane spray foam water based
TECNOFOAM HFO

Polyurethane spray foams, HFO gas based
TECNOFOAM I

Injection polyurethane foams

PRIMER

Primer range
TECNOTOP

Aliphatic top coats
SUBSTRATE PREPARATION

Products for reinforcement, joints and singular points

ADDITIVES
FILLERS

Tecnomesh 200

TECNOMESH 200 BASE

Polypropylene mesh

A non-woven mesh made of 100% polypropylene fibers, heat-set on one side, and calendered on the other, with a  mass of 200 g/sqm, offered in rolls. Is a specific material to be used in Tecnocoat application where the substrate is very irregular or on the soil.



Uses

For use in these types of situations:

  • formation of ponds or lakes on land or natural substrate (soil)
  • creation of a substrate able to be applied by Tecnocoat membranes in concrete substrates in bad conditions ( such a  foundation slabs or floors).
  • in existing supports of asphalt sheets with cracks and very deteriorated.d.

NOTE: call our technical department about the application to other substrates or scopes of use

mass 200 g/sqm
average thickness 1.40 mm.
transverse resistance 800 N
longitudinal resistance 330 N
transverse elongation 55%
longitudinal elongation 60%


TDS. Technical Data sheet(PDF)
MSDS, CERTIFICATES, APPROVALS...(link)

APPLICATION METHODOLOGY

Spread and nail the mesh directly to the support using wide-head cloves. Make overlaps between layers of between 10-15 cms. to achieve homogenization of the surface, therefore, the maximum cohesion of the whole rolls. Apply Tecnocoat on the Tecnoband 200 Base joints first. Apply Tecnocoat, on the rest of the surface according to the total desired thickness on the project.

PACKAGING

Roll of 105 sqm. Measures: 1.50 m. wide and 70 m. of length