GENERAL SPECIFICATIONS

• Single component, solvent-based, polyurethane resin once dry forms a continuous and highly adherent film on substrates such as concrete, mortar or wood, increasing adhesion for liquid waterproofing systems.
• Its consumption depends on the situation of the substrate, irregularities that it presents or level of planimetry. Apply thin coat, never thick.
• In repairs and membrane overlaps its consumption is between 50-100 g/sqm
• The application must be carried out in conditions of non-presence of moisture in the substrate or water from the substrate or backsplash, either at the time of application or afterward (pressure by groundwater level).

PACKAGING

Metal tins of 10 kg.

STORAGE AND SHELF LIFE

12-months shelf life is stored in original containers in a dry environment at a temperature between 5-35 ºC (41-95°F). Keep away from direct sunlight, extreme heat, cold or moisture. Once the tin has been opened, the product must be used.

APPLICATION METHOD

General cleaning of the substrate, removing existing dust, dirt, grease, or efflorescence . Application with a roller, brush or "airless" type equipment on the membranes in areas of overlaps or recent repairs. In the case of membranes older than 3 weeks, it will be necessary to open their pores using some physical method.  Repairs/overlapping/adhesion promoter in cured membranes, its consumption is between 50-100 g/sqm.

HEALTH AND SAFETY

Respiratory Protection: When handling or spraying use an air-purifying respirator. Skin protection: Use rubber gloves, remove immediately after contamination. Wear clean body-covering. Wash thoroughly with soap and water after work and before eating, drinking, or smoking. Eye / Face: Wear safety goggles to prevent splashing and exposure to particles in the air. Waste: Waste generation should be avoided or minimized. Incinerate under controlled conditions in accordance with local laws and national regulations. Re-occupancy of the work site without respiratory equipment is minimum 24 hours providing the correct ventilation for the area sprayed. Contractors and applicators must comply with all applicable and appropriate guidelines for storage and safety guidelines.These safety recommendations for handling, are necessary for the implementation process as well as in the pre and post, on exposure to the loading machinery.  Dispose waste in accordance with star or/and local regulations.

TECHNICAL AND CHEMICAL PROPERTIES

Results performed in the laboratory at 23ºC (73ºF) and 50% RH, under controllable conditions. These values may vary depending on the application, climatology, or substrate conditions.